Welcome to Our Community

Some features disabled for guests. Register Today.

Router11 Installation

Discussion in 'CNC Mills/Routers' started by Maximilian Zödl, Jun 26, 2023.

  1. Maximilian Zödl

    Builder

    Joined:
    Jun 23, 2023
    Messages:
    9
    Likes Received:
    0
    Hello there, i was wondering if there are any possibilities to connect my Router to my blackbox so the program can turn it on and off itself and i dont need to do it by hand before starting a project.
     
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    14,921
    Likes Received:
    4,291
  3. Maximilian Zödl

    Builder

    Joined:
    Jun 23, 2023
    Messages:
    9
    Likes Received:
    0
  4. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    14,921
    Likes Received:
    4,291
    Unfortunately the IoT is 110v only, checkout your local regional suppliers for something similar that works on your voltage ranges.
     
  5. Maximilian Zödl

    Builder

    Joined:
    Jun 23, 2023
    Messages:
    9
    Likes Received:
    0
    Okay thank you, do you know the Blackbox output voltage that goes to the IoT by any chance? Is it 12V?
     
  6. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    14,921
    Likes Received:
    4,291
    Maximilian Zödl likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice