I have the Blackbox X32 and got my IOT in today. Two wires connected to the Tool connector polarity connected right but I have no idea what settings I need to change in grblhal so it’s enabled
I have the router plugged into the NC and the control wires plugged into the Tool sensor but if I enable the Spindel it doesn’t turn on. I will check for voltage on the control wires when I get home
You want it in normally OFF (Relay turns ON to complete the circuit and turns on the router when commanded) Refer the docs: docs:blackbox-x32:connect-dewalt-iotrelay [OpenBuilds Documentation] Remember the power switch on the IoT and the Power Switch on the Router!
I got it working... one of the control wires was not in the connector so it wasnt making contact. Thank you for your help!!!!!!
