To whom it may concern: I have two Meanwell power supplies, one for the spindle and one for the Openbuilds X32 Blackbox controller. I operate with 220VAC in South Africa. Power supply for controller is a Meanwell LRS-350-24 supply for 24 volts to the controller. Power supply for the spindle motor controller is a Meanwell LRS-350-12 supply for 12 volts to the motor controller. I would appreciate a recommended switch for each one. I want each power supply to have a switch. Thank you.
docs:powercase-v1.9:start [OpenBuilds Documentation] should fit the 12v too, if its screws are all in the same position as the 24v (suspect so, you have them on hand - quick compare) Available seperately from PowerCase Kit
I have only checked the kit I recieved now and I do not see the M3x10 spacers. I want to replace them. Am I correct they were made of plastic. I am based in South Africa and I am looking for a supplier. Any suggestions would be appreciated. Regards.
Best to contact the store if anything was missing But Communica, Mantech, RS, Hobbytronics, maybe even Robotics.org.za should all stock M3x10mm female-female spacers. HP-10 - SPACER PLASTIC FEM-FEM M3x10 Takelot has little variety kits of all sizes too
Thank you, Peter, Much appreciated. I was mainly concerned it they were made of plastic/nylon. Thanks again.
Does not matter nylon is cheapest. Brass is nicer. Whatever you can find, they just mount the front panel mechanically. Boer maak plan can work too
