Hi I have my machine working perfectly with USB no problem But now i have to move my laptop a bit far away for CNC as my shop becomes too tight I have internet on my IPhone only and not sure about reliability specifically if i got a call Tried to connect once but didn’t work Any solution please,
Install a home wifi network (access point that BlackBox and PC can both be connected to) Or even easier: get yourself an OpenBuilds Interface "no more laptops" - run it directly from Interface
Thanks @Peter Van Der Walt You the device that extends wifi ? My shop is not close to home Interface will cost a lot with shipping What about direct access to BB32 wifi?without existing network I see this option on my laser and some esp32 controllers Or Bluetooth extension
Enter $$=73 on the console to see what the available options are, if AP is not an option (say it only allows 1 and 0) then you'd have to ask on the grblHAL github issues why, not sure Otherwise, lets not complicate it and stick to my original advice
Thank you again Asked github and they told me to flash through web builder I tried first 3 axis firmware on CONTROL but same Then went to web builder and It’s working now
