Has any one tried this controller i cant find any info on it and I bout it before I researched it some body please tell me if it any good and any information on it would be greatly appreciated https://www.amazon.com/Yuly-100Khz-Breakout-Interface-Controller/dp/B07QP61C66
Agreed. Don't. To amplify, it will require a mach 3 license and a PC with a parallel port. An Arduino and a shield will be much cheaper and do fine.
this is the actual one I bought I posted the wrong one first and didnt know how to change it. sorry for the confusion I am currently using an Eleksmaker Eleksmana ver 5.2 and it does great job nut i need to be able to push more power to my stepper motors and sadly I already purchased thie above controller. I will try to use it but worst case I learned a somewhat cheap lesson. but also this board has now parallel or com ports only the usb port. I like using estlecam can you give me the name of a controller card that can push 3.5 amps to my stepper motors.
Blackbox from Openbuilds BlackBox Motion Control System. There are others, but I am biased Alex. And software to control it is available from Openbuilds for free.
If you use Estlcam and like it, you can buy an Arduino board and DQ542ma drivers. I use this combination with Estlcam. But, if I were doing it now, I would use the Blackbox because it would be easier with the required amperage for my needs
