Separate names with a comma.
Some features disabled for guests. Register Today.
I built a C-Bot 3d printer using all openbuilds hardware little over two years ago, it's currently powered with a RADDS\Due combo, but I'm a big...
I just learned that if you don't like the Google+ 2-column staggered view (which I don't actually), you can go to your prefs here: Google+ Under...
I get to each their own and all, and I know my opinion isn't going to sway someone already set against something, but I've always found google+...
Yah, thanks Carl: Personally I'd just shut this 'OpenBuilds Discussion' down (if you can?) and use the G+ group exclusively, will be far more...
Just tossin' it out there; How about changing the microstepping on your extruder driver? I honestly don't know if it would have any impact, but...
I have the exact opposite experience with their 'automatic supports' : It will leave any sort of floating feature completely unsupported, I've...
According to the latest release of S3D (3.1.0), they have a release note that says they 'Improved filtering for small movements during toolpath...
For those of you talking about aluminum build plates, here's a repost of my blog talking about converting my cbot to one: Building the C-Bot 3d...
Right, you should be able to turn them easily by hand, that'd be the first place to check: Zero binding in the system. Also, if you try to...
I've been quite pleased using Due\RADDS\RepRap Firmware since I upgraded. Able to print way faster than I even could with Marlin. While I...
+1 for problems\issues & fewer categories the better. I like the short list above.
Ouch, I've got the exact same one. It just dawned one me that I build my C-Bot one year ago this month (which means that relay of mine has had...
Yep, the direct-drive design that Carl made, plus my big-arse fan on it. Honestly my belts aren't uber-tight, They have some play when I press on...
I've tested up to 180mm\sec and not had any slippage. That's not saying the print quality was stellar, but there was no slipping. My first guess...
Agreed: Github fine for code\stls, but we need a forum for the forum (or I'd still be fine with a Google+ page personally...;) ).
