Separate names with a comma.
Some features disabled for guests. Register Today.
good day to all in the forum, I have a cnd driven by the GRBL and I installed a 1,6 w LASER after having remove the Z motor. I am searching for...
good day to all of you in the forum, I have a GRBL ver 0.9J installed and works well on my three stepper motors machine. I have now installed a...
@ Surley, could you please give me some more detail / procedure on how to use the program to achieve the painting ? Thanks for all . Ambro
Thanks Surly, I have the following pens:2PCS CCL Anti-etching PCB circuit board Ink Marker Double Pen For DIY PCB They resist well to my etching...
Thanks Rob, I am not an expert on those things: could you please give some more details on tools chain please ? Any useful link ? Regard, Ambrogio
great GRBL ! I have my GRBL CNC working well. Now I have coupled a PEN HOLDER having two springs directly on the Z axe with the intention to use...
thanks a lot Sonny for the explanation. Now a lot of things are clear to me . Regards, Ambrogio
Hi to all in this forum, I am still running v 0.9j; I have a question on the $5 "limit pins invert , bool ". $5=0: I am using Normally Open...
Let me attach the two different pin_out relevant to GRBL Arduino Nano. Thanks Ambro
Found !!! there is a mistake in the pinout diagram in my hands. D_10 is Y and D_9 is X limit !!! >> Could someone post the correct pinout...
I have 5 Vdc on each of the board input switch and I have 0 Vdc when the switch is pushed. On my schematics I have D_10 X_limit, D_9 Y_limit,...
I disconnected all the switch wiring from the board but still have the message: ALARM: Homing fail. Ambro
Thanks for all the assistance, I did follow step by step the procedure. Now the Z is not activated at $H. As soon as the X moves ( few millimeters...
Hi, I modified the config relevant to the v 0.9J but the Z still moves at the beginning of the homing cycle and then the fail message comes on. I...
Thanks Steve, Do I have just to " save" in wordpad ? How to create a file to send to Arduino please ? Where should I have to connect the Laser ON...
