Separate names with a comma.
Some features disabled for guests. Register Today.
yeah, I know that the Control software has the XYZ probe interaction, but as I will be returning the BB x32 and Interface, but not the XYZ probe,...
Hi Peter, So in the end the client does not want to continue with this install as-is... I suppose partially (at least) my fault for not seeing...
https://robu.in/wp-content/uploads/2015/12/MA860H-Digital-Stepper-Motor-Driver-ROBU.IN_.pdf page 4 says 5v - 24v signal .. will have to use a...
Leadshine M860, having trouble finding exactly that info... :-/ plenty about max amps, microsteps, etc, even to use resistor if using 12 or 24v...
BB x32 am using ;-) 5v was referring to the old PCB and its separate powersupply (of 5v)
well at the moment the machine has both Y axis drivers to the same signal pin, so I could configure the BB as if dual Y motors, and wire to Y2...
Look like original Leadshine, quality stickers and a (supposed) QC check too
to resume.. the drivers have stp+ & dir+ wired to +ve powersupply, and -ve signals.. this I will swap so the BB is connected to stp+ & dir+ and...
Thanks for the quick replay, what do you think would happen if I leave "as-is" (as mentioned, the actual PCB has the driver signal wires connected...
Hi Peeps, been a while ;-) am doing a conversion of a large old chinese CNC, it has external drivers (with 75v dc) so will be soldering to the...
Hi David, Really interesting info! And as life goes, yesterday I found this article: Phil Barrett's PicoCNC Aims to Provide Professional Laser,...
Hi David, I must first admit that I wouldn't know where to start with that! I'm proficient with hardware, and understand enough software to be...
Morning Peter! Thanks for the quick response as always, yes, I have seen the docs about the BBx32, really a big step up from the original ... had...
Hey guys! been a while ;-) Got a new project, converting a CNC Jiachen JD-1325DSX, it is an old 2008 version, would like to add BBx32 + Interface:...
Hi Peeps, feature request/ change, PLEASE MAKE INCREMENTAL JOG DEFAULT 0.1mm, NOT 10mm!! this has tripped me up several times, as my 'flow is...
