Separate names with a comma.
Some features disabled for guests. Register Today.
Oh, ok. I understand now. They attach the gantry assemblies to the vertical C-Beams with tee nuts. I don't know what they're like without them,...
Sorry, I'm not really sure what 4 shafts you're referring to. Are you talking about the 20x80s on the front and back? Your machine looks good,...
I ran a dial indicator down the length and it's not like MIC-6 tooling plate, but when you add a spoilboard and face it, it'll be as flat as...
Thanks! If I remember right, it should be about 850mmx850mm in X and Y. Z has a 250mm travel, but that's going to depend on router size and...
Thanks! I had lots of doubts about posting it because I hadn't shown it to anyone else, so it means a lot to be hearing good feedback from the OB...
I think it'll come in handy for some t-slot style clamps. And it was way way cheaper this way than the pre-made fixture plates I've seen online.
Nice! I was finally able to finish my submission just now. Because it just isn't fun if it's not done at the last minute.
Step 1 Fixture Plate Materials Needed: 10x - 20x80x1000mm Extrusion 3x - 20x60x1000mm Extrusion 100x - Black Angle Corner Connector...
blterry1 published a new build: Here are the instructions to build the Beeline custom CNC router table. Read more about this build...
7lbs. 13oz
