Separate names with a comma.
Some features disabled for guests. Register Today.
Very, very nice but $400 USD
Yet another item from my wish list … It would be nice if the standard 10 pin debug header footprint is on the final board. A J-Link is a...
If it's not too late, please attach the endstops to pins that have pin change interrupt capabilities. This can relieve the CPU of having to poll...
NXP Cortex M3 I hope it's not one of the LPC176x processors. They're OK for minimal systems. They just don't have enough I/O pins once you...
Are you using belt tensioners?
This resource is no longer needed. "Force all Gcodes on for Marlin" option set to TRUE takes care of most of the issues. Marlin as of RC8 now...
Go over to Thingyverse and click on any design. A 3D printing service will be on the page. They'll hook you up with a local printer.
I’m slowly going from dream to practical on this project. I do a lot of repairs and DIY projects around the house and just got sick of throwing...
I just switched over to the Allegro A1125 hall effect switches. They work just fine. Now all my endstops & the BLTouch are set to "false" in the...
The bleeding edge of Marlin now has radius format support for the G2/G3 commands, has G38.2 & G38.3 commands and will soon have M3, M4 & M5...
I just ran into what may be the holy grail of hall effect switches. It's the "NC" version of the hall effect switch. The Allegro A1125 output is...
I'm hoping to start a discussion of people's favorite ways of using & mounting hall effect sensors for limit switches / end stops. Attached is...
With 23HS41-1804S steppers I'm running reliably at 35mm/s. I picked those steppers because they were low current & high power. Just didn't...
Agreed - single actuator is much simpler and doesn't have the possibility of getting out of sync. I'm thinking of going to a single central Y...
