Separate names with a comma.
Some features disabled for guests. Register Today.
Hello all, I am using a GRBL Controller to drive my OpenBuilds OX CNC Router. I really like the way Delcam FeatureCAM works, and was wondering...
I was wondering what the best power supply to run this build is? I was running a 24V/20A power supply... Somehow the MOSFETS blew out when i...
Hey guys and gals I've followed the instructions for KRAM's CNC OX Build. I was wondering what the best power supply to run this build is? I was...
Joe, You rock! I'm running GRBL 0.9G GRBL Controller 3.6.1 See attached photo of the GRBL settings.. I can't seem to find jumpers for step...
Joe, I didn't quite figure it out.. Im using the motors on the open builds part store. I moved the pots on the board until the machine was...
Would someone be so kind as to post their GRBL settings on here? (0.9) I've used everything listed in the Openbuilds store. Using the settings...
Hey guys, thanks for all of your help on this! I have a Protoneer CNC GRBL Arduino shield. It is being driven by 4 StepStick A4988. 24V 30A...
Okay I get it. What I don't get is how is 30 amps not enough to power the drivers? I get that the motors will be underpowered, but adding more...
OK, so I need to lower the voltage of my power supply. How does this effects the amount of amps going to each stepstick? It sounds like I need...
Okay, so it sounds like my polo driver board isn't the right choice for the OX. Lowering the voltage to 14V would fix the choppiness on the...
Hold on.... So I ordered the wrong pololu drivers? Would these be more suitable for a nema 17?? Without lowering the voltage on the power supply,...
Thanks for the reply! I'm running a 24V 30A Power Supply. Plus.. StepStick Kit (4pcs) A4988 Stepper Driver Brayden
