Separate names with a comma.
Some features disabled for guests. Register Today.
Front is no stepper, the end plate here will need modifying. For the rear, with the stepper no change required to the end plate, but the build...
Here's a picture of the bed showing the relief required for the stepper. If you want the additional travel at the front the bed and relief would...
Just measured the travel I have in the ynaxis, I get a full 11 inches of travel. With a bit of work on the front cbeam end plate I think I could...
I'll see if I can measure the travel tomorrow.
I've got one of the 400 watt brush less spindles. It will cut aluminium. I've cut 10 mm thick aluminium with mine, wasn't quick though.
I think you loose about 3/4 of an inch travel going forwards. If you want to access this I'd buy a spare cbeam end plate and mill the top to give...
I'm no expert (new to CNC) but I also have a C-Beam but with a 400 watt brushless spindle. For wood I brought a 1/4 inch set of router bits from...
I'm using a smoothieboard on a cbeam and like it so far. I'm new to CNC but enjoying the challenges.
As regards 3 check out RepRap 3D Printer Parts Supplier - V-Slot CNC - Ooznest they do an OX kit, and are a great supplier. Ryan also posts on here.
A Sunday afternoon saw my C-Beam assembled, a great kit, thanks @ryan. Last night I wired up the steppers, taped on a pencil to the z and drew a...
Decided to join the fun, just ordered a kit from http://ooznest.co.uk plan to use a smootieboard and a 400 w brushless spindle.
