Separate names with a comma.
Some features disabled for guests. Register Today.
how come most of these electronics max out at 2.5 amps. there are many nema motors that have a pretty high torque ratings at 2.8 amps. Meaning...
in vcarve, instead of exporting out the gcode, save the file instead. File > Save method. It may have been your set screw that was missing. I had...
Also that image, does not look like it was done with a vbit. What wood are you using?
Can you give me the actual aspire vcarve file. I want to see how it plays out there and create a gcode from that file myself. Please and thanks
maybe your running the machine faster than it can cut? Its skipping on the right side, so something is getting stuck when it gets there. Is there...
In vcarve, export your toolpath as G-Code inche (*.tap) I have used that to run stuff in mach3 and never had a problem with it. Test that post...
I have a shapeoko as my base and building a ox for bigger stuff, I had a similar issue and was pulling my hair until someone came along and...
open so when you create a toolpath, you select either pocket or profile or drill or V-bit, they all usually have the same setting to play around...
Sorry, let me get this straight. -You do all your design and export -plug it into mach 3 -push start -Z axis keeps going up without stopping? -Is...
Yes and No, I have asked the same question in another board, and the response was it all depends on the amp and volt requirements, there are some...
Its doable, if you know how thick each layer of paint it and you move the mill down only that distance per pass it can look quite amazing
The 8mm threaded rod in the store is 1000mm in length. Does that need to get cut down in length for this project? 1000mm is 3feet. I doubt that...
What mounting plates are you using for the z-axis motor?
They were left over from a previous cnc table build, which turned out to be more of a problem and mess, (costs more to fix it than it is to build...
Hey guys, I have 4 Nema 23 motors from cnc router parts, as well as the G540 setup, can I use them for this build? Info about the motors. Step...
