Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks Peter, I found the link to SketchUp's site first. I'm using Mac OS BigSur version 11.7.10 which is the latest current OS. I'd hoped...
Guys, thanks. FYI SketchUp Make 2017 is no longer available for download. See this page https://help.sketchup.com/en/make-access. I got excited...
Ok so I've looked at a few videos. I tried using the free online SketchUp to create a test project to bring into OpenBuilds Cam to add tool paths...
Mark and evili66, thanks for your replies. When we started way back Open Builds was the first place I saw a total solution ie we were told if you...
Well it's now been 10 years since I built my C-Beam. It's still pretty stock though there have been a few mods made. At the time there was videos...
Rats. I'd hoped there was another (many) trailblazers like me who had tried it, but had perfected it, which I did not. You see a while ago I tried...
As 98% of my cutting is .032" thick aluminum sheet, my bit goes through the material and into the spoil board every cut. So that idea wouldn't...
Yes my 50's era Atlas 10" has flex, I understand. I should have phrased my question better. Considering the rest of my C-Beam is basically stock,...
I have a fairly stock C-Beam I use to primarily cut .032" aluminum sheet. I use a coolant mist/spray to do it. I currently have the standard 3/4"...
Not seen in the photo, my current router clamp, is that there are 4 black corner connectors holding it, 2 on the top and 2 on the bottom. Would 2...
I see how you might have done that Stwspoon. Thanks for the idea, I like it. There is 20mm under the z column I can get. Attached is a picture of...
6 years since I built my C-Beam, back when this thread first started 55 pages ago. I've done a few minor modifications to it but most of the...
Thanks Rob. I did not know Fusion 360 is free for hobbyist use. I assume design drawing is done and cut paths created and gcode generated all in...
Built a C-Beam in 2015 and have been using it since about every 2 or 3 months to make stuff for my many other hobbies. Have had lots of fun along...
