Separate names with a comma.
Some features disabled for guests. Register Today.
I have VCarve Desktop as well and although I haven’t tried it yet it is my understanding you can use tiling to do larger pieces as long as your...
Thanks Peter. Looking better now. Don
The software told me there was an update available this morning so I downloaded it and installed it and I am now at version 1.0.74. When I opened...
There are two basic types of lasers, Diode and CO2. (There are others but they are not used very much by the diy'ers). To cut wood you will need a...
Per Mike from Sparks Concepts: >>The LEDs are there to show motor power for each coil (red is coil A and green is coil B) - all this means is you...
You are absolutely right. I made an assumption about how the machine is configured. I should of asked more questions.
The Y motors can't both go in the same direction. One has to, for lack of better term, go forward and the other motor has to go backwards. This...
Without a fan the xPro tends to overheat. If it doesn't work after the board has cooled down there is a good chance that the board is fried.
Do you have a fan for your xPro?
Have you already purchased parts? If not then you are basically describing the Acro System OpenBuilds ACRO 55 20" x 20"
Have you tried changing the Baudrate? It's hard to tell from your screen shot but it looks like 9600. I use Laserweb to connect to my xpro and...
When you guy’s where showing the APEX system you had a nice looking controller case. Can I assume you are using the same or similar case with the...
Not sure how much help I can be but I'm going to throw out these ideas and hopefully 1 or more will help you. Do you have the latest version of...
The LED changes colour based on the direction the stepper is rotating.
The LED's go red when the stepper is rotating in one direction and green when rotating in the other direction.
