Separate names with a comma.
Some features disabled for guests. Register Today.
Won't bore you with the seems like hundreds of things we tried, the culprit turned out to be the remote mouse. Was apparently sending false...
An update: tried 3 different ports on the PC and a new cable. Same result.
My machine will no longer "home". Z axis raises till the limit switch, the X axis then jerks twice to the right and then everything stops. All 3...
Thanks everyone.
Can I add a question?? What DOC's are you using for the listed cuts?? Both my Amana and SpeTool Feed and speed charts recommend 1x bit diameter,...
I had a similar problem with the units measurement. Have always used metric so didn't notice when the program opened and had switched itself to...
No I hadn't. thanks for the reminder.
My machine stopped in the middle of executing a program. Error message I get: PORT ERROR: Writing to COM port(GetOverLappingResult): Unknown error...
Thank You
Trying to setup a command button to check the Z axis is moving the prescribed amount. Here's the code; G91G21 G0Z10.0; G0X50.0Y50.0; G1Z-5.0F300;...
Are there grbl compatible boards other than the UNO with more flash memory?? Apparently grbl uses 92% of the UNO's memory and triggers a warning...