Separate names with a comma.
Some features disabled for guests. Register Today.
Ok my sinks are a little big, But after i put them on i did see a small inprovement. So i think i am going to print me a new box with 3 fans and...
Cbrown330 published a new build: This is a big 609 x 609 x 914 3d pritner with exchangable hot ends and extruders. Read more about this build...
I am just starting this build, I have built a small 3d printer already and currently finishing up a OX CNC. I didnt post anything on these 2...
I am running at 8th step, i measured the output voltage while running as was not getting any drop from the PSU. The wire is 16AWG. Now i am...
Ok i am at 24.02 measured voltage. So i am good there. Tried it again with no luck at all. I lifted the X axis at tried to run at 1500, 2000,...
O and by the way i am using a 1/4 inch end mill, brand new and cutting MDF. So the material is soft and the blade is sharp.
well i guess i lied to you both. I am using the 24V supply from openbuilds, its a 14.6Amp. I havent checked the output power though (duh) should...
So the motors are not big enough to run what i need, plus the controller is undersized. Chill i am using a 24VDC 8 Amp supply, not using the ATX....
I just finished my OX CNC build, but having issues with motor current. I am using the CNC xPro controller from openbuilds Nema 23 motor from...
I am looking for a 3d printable file of the 40mm x 40mm v-slot extrusion. I would like to have a plate with the 4 holes aligned so i could use...
well doing some research from Hytech2K i found out they are using Aspire from Vectric. There are demo version available that allows me to open...
Those are some nice software pieces. Looking through the stuff that you can download on the C beam. Do you happen to know what software created...
