Separate names with a comma.
Some features disabled for guests. Register Today.
I would suggest downloading a free trial of a 'real' CAM program such as CamBam. Draw a simple circle in that and generate the GCode. If that does...
I'm no expert, but the pololu website suggests putting a multimeter on one of the pins going to your motor (i.e. measure the current across one...
Lucky you didn't fry it :)
Quick tip for cable management. Well worth getting some of this...
The power supply depends on what spindle or router you are using and what driver board. For example, the protoneer cnc shield can accept between...
Breach plug grease? That sounds like something you'd use on a submarine. :) Thanks for all the replies. I'll start with some 3 in 1 and see how I go.
I got a 8mm screw and ant backlash nut from QTecStore on ebay....
Yes, you could. There are lots of options for electronics, including the TinyG, the gShield and the protoneer CNC shield. All three are good...
Back with another question. What are people using for lubricant on their leadscrew? A specialist product or something more general?
I like the flexi shaft spindle on your site, but 43W seems a little light even for wood. How does it perform on a routy?
Great job. I would prefer a thicker z axis if you are going to put a lot of weight on it though. Maybe even a double gantry plate somehow? Some of...
Cheapest I can find in the UK is closer to $10.
Thanks, I don't really want to buy a dedicated tap and die for just a couple of holes, but I also know that pretty much every screw I have used...
Can you tell me what type of screws you used for the ends of the z-axis v slot? Did you tap them separately or use self tapping screws? If you use...
I have the same as you, but haven't busted out the soldering iron yet (got an unassembled board). Good to know it works fine.
