Separate names with a comma.
Some features disabled for guests. Register Today.
[email protected]
Also, they are 10% off (the fee Ebay charges me) if you buy directly from me... [email protected]
Like Kyo said, all of my plates have precision counter-bores so non-flanged bearings can be used. I am not sure about the Openbuilds plate...
I make the plates one at a time on a custom precision fixture using 10 different carbide endmills and cobalt drills, chamfer and polish both sides...
Hi Duncan, Thanks for the input! My plates are 6.6 mm thick, so I will calculate accordingly. I like the idea of mounting the nut directly to...
Hi Duncan, I like your ideas. I did notice a few minor issues with the Y stepper plates... the spacing is a tiny bit off.. .7774" vs .7874"....
Hi All, I have started designing fixture plates to make the 6 plate set... I have simplified the X extender plate and made its 4 stepper holes M5...
Hi Guys, Daz agreed that I can make and sell these kits. Daz, please let me know if the situation has changed. Please email me if you would like...
You can reach me at [email protected] for any custom parts you may need. I ship world wide. Thanks :)
HI Wassim, I have a few gantry plate sets that are 2" taller. I think much taller than that compromises stability. They are listed here:...
What RPM are you running? It should be about 3,000 7-8 IPM should work better, and try .02 depth of cut. Is it a slot cut or edge cut? You...
Where do you get this 1mm shim?
Accord According to the dimensio s of the wheels, they differ by 1.43mm, which means either making the large wheel spacer shorter by .715mm or...
I assume someone has mentioned it, but is there a fix for fact that the center of the large wheels is .71mm farther out than the center of the...
Please send me a msg at [email protected] Thanks S
