Separate names with a comma.
Some features disabled for guests. Register Today.
Wow...thanks for the link! A minimum feed rate of just under 50mm/min is exactly what I'm experiencing. I don't know enough to fully understand...
I’m using Lightburn to run a laser module attached to an X-Carve using the X-Controller (GRBL). I wasn’t getting the cutting results I expected at...
OK...thanks! I was thinking of using the 28s to raise/lower a pen on a pen plotter I'm building. I've been using a servo that works OK so I'll...
Just wondering if I can use the Black Box to control this stepper motor??? 28BYJ-48 - 5V Stepper Motor Thanks for any constructive suggestions!
Excellent...thanks!
Will the relay connection on the Black Box control a 24VDC, 4.8watt solenoid?
Have you seen the files (e.g. .stl or .dxf) for those plates somewhere? I've found the shims on Thingiverse, but not the plates.
I just re-read the introductory comments from the OP and see that he states the plates and shims need to be custom printed.
I've just about collected all the parts and hope to start the actual build next week. As far as I can tell, the parts list doesn't include the...
Just wondering if anyone is still following this build??? If so, I'd like to ask what the flat supports for the mirrors and laser head are made...
