Separate names with a comma.
Some features disabled for guests. Register Today.
I sent an email to them about the build volume and the print area is a cylinder with a 160mm diameter by 160mm tall. Prints both PLA/ABS
Amazing. How much do you suppose you have into the project? The quality appears to be better than what I have seen in some of the "entry-level"...
Here you go. http://forums.reprap.org/read.php?1,286862 Looks great.
Looks good. This is actually something I have been planning on doing myself, glad you beat me to the punch and saved me all that work ;). I don't...
I assumed there was some structure that was added but wasn't certain if that was the only reason. The tube does seem to tie in really well with...
What is the purpose of the tubes that run parallel to the sides of the gantry plates?
I was afraid the clear wouldn't be doable but I thought maybe the engraving plastic would be a possibility, since it is colored. I just haven't...
I was wondering if anyone has had any success engraving plastic with a laser diode. I am looking for something that can make custom electrical...
