Separate names with a comma.
Some features disabled for guests. Register Today.
Well, I guess 8mm will be fine as the plates are 3mm thick and if 8mm isn't long enough then I have a Dremel and I am not afraid to use it either,...
Well, all plates, and motor mounts, are from here so 10mm is what I really need? I sure don't want to bottom out.
Precisely as I was just adding that bit of information that Rick forgot about. I can't wait to see what new instructables come out now.
In order to enter this contest you must be logged in and have published an instructable since the launch of this contest.
Do all plates, and motor mounts, take 8mm as well?
LOL. What I am trying to figure out is why 10mm is even brought up, not just by you, since you would have to file the tabs so it seems the tabs...
Well, this is what I don't get as I have yet to buy any of this but I have my order being made (hence this thread) but don't the tabs go into the...
8mm for every plate, and motor mount, then? The tabs I just do not see how 10mm is needed because the tabs don't run the entire length.
When using these [IMG] with the plates that you sell and this [IMG] what length is needed? I have four hundred drop in tee nuts so I need to...
Thank you.
Ahhhh, in the pictures they make it look thick like double sided tape.
Oh, wow 10mm too? 50 corner brackets and 20 plates then the odds and ends to hold motor mounts and my printed parts. My deal isn't the PEI being...
If you would check but what do I use for these corner brackets since they are far from 4mm thick (I believe they are 3mm thick)? [IMG] btw, those...
The pictures so I could really zoom in on the parts but all you can do is get a little bigger by clicking them. What sucks is how much these...
