Separate names with a comma.
Some features disabled for guests. Register Today.
Awesome love the conversion! I'll have to do that to my 1000mm by 1500mm OX. I should make it smaller!
One Control Omega Control
Here are the settings I use.
What g code sender are you using, I found by using the universal gcode sender resovled my issue with noise steps.
I got it working with shorter wires, but I still find it a little flakey. Using the 5+ and ground. I just need to wire up the limit switch just as...
I take it you havent wired up the homing switches or the start/hold/reset ones ether? I build my ox about a year ago, but just started to have the...
Thank you! Could you make a vide on your wiring setup?
Is there a way to setup a z zeroing touch plate with the xpro board?
I have a fan on the xpro and heat sinks on the driver chips. Just run the fan from xpro connection.
Awesome built and prints! What software did you use for the prints?
Is there a way to upgrage from 0.9g to 0.9i and if so how?
Hello, Could everyone that has a spindle mounted post some pictures as how they have attached the spindle to the OX build. Thanks,
Currently I'm using 24v 10amps power supply, I do recall seeing a post where to stop chatter they replaced the power supply. I did a test...
I have run into the same issue with Nema 23 chattering at anything under 50 feed rate, have you been able to resolve this issue? I also ordered...
