Separate names with a comma.
Some features disabled for guests. Register Today.
Think I am done with adding all the features I wanted to this thread program. A week or so after initially creating the GitHub repository for this...
If you are looking for a plotter with repeatable accuracy, this is not it. I was never able to get the accuracy I wanted with this machine but...
Since using Fusion 360, screw thread limitations have always bugged me. I was used to how flexible you could change all the variables of a...
I had to do some tuning to my printer this week as my prints were not coming out as well as I liked. I tightened the belts, eccentric nuts,...
This is a little sloppy fit which I kind of expected, but more so than I thought. I added some more support for that inner gripper as that bent a...
Since Fusion 360 displays the Pitch diameter as you change the module size, I used a spreadsheet to work backwards from the Pitch Diameter needed...
I decided to revisit this 3-jaw chuck design for a vertical pen mount. I couldn’t figure out the spiral path a couple of years ago, but after...
I decided to add a drag chain to this rolling plotter. I spent more time than I care to admit getting this the way I wanted. My 1st big mistake...
That looks like a nice simple design that would be a lot easier to build. You should not have any accuracy problems with that once you have it...
I read your message a little closer & see that A0 size paper is 1189mm x 841mm (46.811" x 33.11"). That is a pretty big sheet size. Biggest...
I looked at doing it that way, but after playing with that idea a while, decided to use a similar setup as I was with the servo motor. It will...
The BlackBox does seem like a really nice controller. I think it would be overkill for me in this situation though.
Thanks for the info. It is good to have that info in this thread. I had not looked at using OpenBuildsCAM for this, mostly because I wanted it...
My experience with servos for use with this pen plotter has been that great. I probably didn't do enough research into the use of servos with pen...
Good idea. I will see if I can get the info together in the near future to add separate build for this. I did redo the pen gantry to use a...
