Separate names with a comma.
Some features disabled for guests. Register Today.
From a old guy, To make a servo system fully run to it's potential you must have a dual trace 0-scope.. one channel on the "signal" and one on the...
[MEDIA] And it looks like it will work as a 23"x24"x6" 3d printer.. note the new mods, Hardy-concrete backer floor board with nichrome wire insert...
Hi, I loved the CNC-ed embroidery machine you did. I do have (2) machines sitting here gathering dust. One Consew walking foot machine suitable...
New project I am kinda excited about, a cnc knitting machine, ordered the parts a bit ago for the bed and needles from England.. I am using a...
Purchased another Gecko 203V. Installed it, the 280 oz Z motor back onto this machine. Purchased that factory reconditioned Bosch "palm" Router...
So, I had my new machine connected to Mach3 parallel port, configured, running correctly. Calibrated. Then I decided to put the 3d printer board...
I was a electrician since the late 70s, instrumentation, robotics, Mostly retired now. PROBLEM, at one time in the 80s everyone had their own...
I just thought I was close to cutting parts out. I tried to calibrate this rascal, whereas, you tape a ruler down to the bed, shoot the machine...
Video of the machine running, still to build a trapeze for the cabling, and put the electronics in a box to protect it. Onto the next build.. I...
IT runs.. way too fast. I am using the gear belt for the 3d printer, at 1500 ipm and it changes directions it slips (inertia is a *****). THE...
Would not be as pretty, but more available to "college kids" who are strapped for cash.. Post these drawings on this site. PUTTING OX plates,...
Hi Buddy.. Had a rough night-day here.. woke up at 2am, could not go back to sleep, went to the shop at 5am, ran a cambam program doing a...
