Separate names with a comma.
Some features disabled for guests. Register Today.
I look forward to seeing this. There is a good chance I will be bugging you to buy some :)
So I have done some test cuts after making all of the modifications to my machine. I am not happy... The torsion problem I was having before is...
I want wheels and bearings that accept an M8 bolt! Perhaps the 608ZZ 8x22x7 - a common bearing for skateboards and roller blades. The M5 bolt is...
If I want to change the belts to a different type, I can flip the rail over and use the other side. I figure I have two chances, and if I need...
Serge, How has your build progressed so far? I wanted to share the progress I made to my machine this weekend because my design is inspired in...
I finally found the L-Brackets on amazon as reference for other people. An Amazon search for "Faztek floor mount" should point someone in the...
I originally built the OX to the (almost) standard design. Seeing how you mounted your Y Axis rails to the table inspired me to change my design....
Ive considered (and may still do it once my workbench is completed) just swapping the gantry plates to achieve this. The nema23's I have are very...
I had that exact same idea!! I was trying to figure out how to explain it without sounding like a moron. It essentially turns it into a rack and...
Thank you for your response. I can assure you the motor is not budging. It would have to pass 7 full steps in each direction and returning back to...
Do you have any problems with elasticity of the X axis belt? I have a similar design as yours and I have about 1.5mm of movement each direction...
