Separate names with a comma.
Some features disabled for guests. Register Today.
I am moving house and will no longer have a garage. Looking to sell/ trade the OX CNC machine It does need finishing off and wire tidying etc,...
Can this discussion be to help me solve my ox problem with the xpro that I have at the moment. All I'm asking for is help rather than someone...
What's the solution or recomendation Jonny?
I decided to test out calibration of the board and so i sent "G21 G1 f400 y150" i did this 5 times along the X to measure the length of Y to make...
Really, on the Xpro Wiki they say you need the current pots at min before stalling? Now confused. I can hear the motors humming on ideal. I've...
Hi Guys Need help... I followed through this post and its great. What can I do? I haven't bolted the machine down to the bench? Is this an issue?...
Hi Ronald I am running 4 nema 23 motors from open build, they are rated at 2.8A/phase. What can you advise? Thanks
Anyone know what fuse I should put to protect the board? Thanks
I've just swapped the wiring on the Y-Clone motor on Board I now have on clone: A1 - Green, A2 Red, B1 Blue, B2 Yellow On all other 3 motors - A1...
The Machine is moving, just lots of shaking. Video attached is trying to make a circular movement (I havent powered the spindle here, just showing...
Hi puntoMx Mounting a fan today 24vdc 60mm. How do I overcome the shaking? What setting do you use for gbrl? II have played around with the...
Hi all, I am a newbeee.... i have the same setup as superelvis above I input the values that Ryan has mentioned above. Thank you but the...
