Separate names with a comma.
Some features disabled for guests. Register Today.
I jut let the magic smoke out of the chip for my Z axis, not sure what I did. Everything was fine I had run several parts and was making a few...
I took a little over a year break from my build, I had a big remodel project going on that's finally winding down. I have been hitting it pretty...
5 Lbs 11 oz
I'm using a 24v 360w power supply, so far so good. NEMA 23 motors
[ATTACH] I sort of got it working I can get it to move down and stop on the touch plate it won't raise up with the next command I put it on the...
Read this earlier post Snokid was very helpful and posted some videos later I used basically is exact settings and my machine is dead on. CNC...
I'm running grbl control with a windows 7 machine I had issues at first and removed all of my limit switches as David suggested. Not sure thats...
I'm not sure if this is what your looking for but in "resources" there a tutorial section this is what I used to calibrate my machine. HOWTO...
The GT3 belt is about twice as thick as GT2 (see graphic) and according to the videos the reason they recommend using is because it's stronger. I...
Disconnected all of my limit switches I think I was not zeroing my machine in the correct order. I think I was loading the G Code and then...
Snokid thanks did some test runs tonight and I'm very close, just need to tune up on G-code and how grbl panel works. I ran the openbuilds logo...
Wow thanks for the video!I'm out in the shop and going to make the changes as suggested. I'll see if I can turn a board into saw dust.
I have limit switches on Z & X didn't order enough for Y. For hard limits doesn't it use the X,Y & Z limit switches? I measured max travel so I...
Definately going to to speed things up I didn't know gcode would override the max speed travel I was worried it would crash big time if I didn't...
