Giarc's Recent Activity
-
Giarc replied to the thread grbl controller using external drivers.
This may help as well. C-Beam cnc
May 11, 2025 at 5:18 PM -
Giarc replied to the thread grbl controller using external drivers.
Why not just use the one 15amp. Have you tried that? Also, have you contacted Makerbase Customer Service? They may be able to help....
May 11, 2025 at 5:15 PM -
Giarc replied to the thread Lead 1515 missing 65mm screws?.
You should have got them(16 total). Reach out to the Parts Store customer service. Submit a ticket They will quickly make it right if...
May 11, 2025 at 5:07 PM -
Giarc replied to the thread Flipping Guitar Neck - and Test Piece -- not lining up.
Is your machine accurately calibrated? If it is off and cuts slightly too big, then it will be off by that much just like you showed if...
May 11, 2025 at 4:39 PM -
Giarc replied to the thread Flipping Guitar Neck - and Test Piece -- not lining up.
On two-sided parts, if the alignment holes are drawn as part of the model then copied to the other side, you are correct in that you do...
May 10, 2025 at 4:11 PM -
Giarc replied to the thread Need help resetting my BlackBox motion controller.
Do your 5v power supply and black box power supply share a common ground?
May 9, 2025 at 3:35 PM -
Giarc liked Peter Van Der Walt's post in the thread xyz probe won't retract.
[ATTACH] Capture log during one of the stalled probes
May 9, 2025 at 3:33 PM
-
Giarc replied to the thread xyz probe won't retract.
What controller are you using?
May 8, 2025 at 11:30 PM -
Giarc replied to the thread Order status?.
Check your spam folder on your email to see if any order related emails were sent there if you did not get an email.
May 8, 2025 at 11:25 PM -
Giarc liked Dion M's post in the thread xyz Probe File.
Wow thank you fellows I guess I was overthinking it for sure! I never even gave it a thought to flip it over! Most of my carves I am...
May 8, 2025 at 11:23 PM -
Giarc attached a file to the thread xyz Probe File.
When doing 3D carves, I always zero on the bed with my OpenBuilds probe. I flip the probe upside down so it sits flat on the bed. I...
May 6, 2025 at 11:18 PM
-
Giarc replied to the thread Laser Rotary Tool / Attachment.
If you can print abs without it warping it should work. I believe the plates are originally 6mm acrylic. ACRO Plate Set
May 6, 2025 at 12:05 AM