Separate names with a comma.
Some features disabled for guests. Register Today.
This may help as well. C-Beam cnc
Why not just use the one 15amp. Have you tried that? Also, have you contacted Makerbase Customer Service? They may be able to help. It may be...
You should have got them(16 total). Reach out to the Parts Store customer service. Submit a ticket They will quickly make it right if they are...
Is your machine accurately calibrated? If it is off and cuts slightly too big, then it will be off by that much just like you showed if zeroing on...
On two-sided parts, if the alignment holes are drawn as part of the model then copied to the other side, you are correct in that you do not re...
Do your 5v power supply and black box power supply share a common ground?
What controller are you using?
Check your spam folder on your email to see if any order related emails were sent there if you did not get an email.
When doing 3D carves, I always zero on the bed with my OpenBuilds probe. I flip the probe upside down so it sits flat on the bed. I set Z zero...
If you can print abs without it warping it should work. I believe the plates are originally 6mm acrylic. ACRO Plate Set
That depends on the software you choose to run the machine. OpenBuilds Control Software appears to be Mac compatible. OpenBuilds Software:...
Did you buy chance tell vectric you were zeroing on the Bed and not the top of the work piece?
It must be a misprint because just below it says 70" by 70" [ATTACH]
I always go with 1/2 of the endmill diameter. I may go deeper if there is a small step over, but I usually default to 1/2 diameter.
Is it a 3 axis controller where one is utilized as the rotary axis when in that mode? If so and the controller is GRBL based, the n the Rotary...
