Separate names with a comma.
Some features disabled for guests. Register Today.
So I figured out the issue. I had two problems working against me. The first was that I used the same colored pair of wire for two of the axes....
From my previous tests, when i disconnected the y direction pin from the driver board, the corresponding pin on the driver board went low. this...
I tested my board with the basic blink example supplied in the arduino ide. I modified it to use pin 6. With my DMM attached I could see the pin...
I have another board, but the serial connection is not very reliable on it. the one I'm currently using is brand new. I will try flashing my...
Hi Sonny, I'm having a strange problem with getting my Y-Axis working properly using GRBL. The Y-Direction pin is always high, so the Y-Axis...
