Separate names with a comma.
Some features disabled for guests. Register Today.
Well done the mods better belts, idlers and shortened X axis, and the machine is far better We can really push it now, perhaps we can finaly...
[ATTACH] [ATTACH]I was asked by Beryl guitars some time ago if I would build them a CNC, having experience with my machine at home and being a...
It can be done but you need to run at slow feed/spindle speed and small depth i.e.: 1 - 2mm, when your cutting a 40mm blank this is not feasible,...
Yes, but the cost of the stronger alternative is prohibitive
Not yet still waiting for the supplier, when the upgrade comes it will be all hands, then I will do a full report on improvments made if any,...
We are going to have to seriously look at what we can use the CNC for, we will certainly down grade expectations and use other ways of cutting...
Well it has been months since we purchased the machine and still not one Guitar off the machine! the supplier has been very slow in help to find...
You should be okay then with thin Plastic sheet
I have to agree with you, we were sold the machine with the job in mind as a criteria, it has not lived up to it in many ways, the cost swayed the...
23 NEMA 1 on X & 2 on Y and 17NEMA on Z, I don't have the exact motor specs to hand
GT3 belts are the minimum spec I would go for, the machine uses GT2 at the moment but I believe it is being upgraded along with idlers for the X...
I will keep that in mind, thanks J
Deflection on X is a problem, not a huge problem I had some defection on the Z axis this was due to the inferior Spindle clamp supplied, I...
I think the concept of Openbuilds is good but much heavier belt or chain is required, x span needs beefing up, we do get some flex here not a...
