Separate names with a comma.
Some features disabled for guests. Register Today.
How about $60 + shipping? (US only)
Hello, I posted this down in the controller boards forum, but I'm not sure if it gets many views down there! So, I thought I'd also try up in...
For some history of it's application, check out the Cebu build thread. Cebu
Not sure if this is the right forum, but I have an xPro v2 for sale. Removed working from my original Ox machine. Heat sinks installed on the...
I have a similar setup, with RPi in the garage controlling my Ox. I left UGS a long time ago, and have settled on cnc.js as the controller of...
You should take a look at bCNC. It has some Cam functions built in, including drilling - GitHub - vlachoudis/bCNC: GRBL CNC command sender,...
tl;dr - Outside cuts (profile) are wrong dimensions, inside cuts (pocket) are correct size. Let me clarify - the pockets are always the right...
Hey, all. I've been continually tweaking and using my Ox derivative "Cebu" All has been working well, for the most part, especially since...
Same setup for me - was a beta tester of the new design. Works great. I am using cnc.js now more than bCNC. -John
I used the self tapping screws from the open builds parts store - Self Tapping Screw I did run out at some point, and found the same screws at my...
The plates I had were provided by @asb_79, and they had several "extra" holes, maybe from an earlier rev of the plate design? The latest plate...
I haven't really run it more than an hour at a time, and did not notice any excess heat.
