Separate names with a comma.
Some features disabled for guests. Register Today.
I had the same problem with slack in a single belt. In the end I layed my hands on a buckle arrangement like adjusters on ruck sack straps, one...
The best way to be sure is remove the set screws and drill out and tap an m4 in them. M3 are just not up to it imo
Why have you added caps in parrallel to your inputs? These will add delay to your switches but shorted over switch have no effect other than that...
Could corner brackets not be used?
s This is what I use. It is strong but it's also heavy. My 1500mm gantry has twin lengths of this with I'd say an extra 30kg in each end plate...
4mm Single flute upcut spiral 8000 rpm 2800mm/min you should be fine. Straight flute will likely give you lots of chatter imo. Have the machine...
Hardware: Check your axis run smoothly and easily I.e your eccentrics are not putting too much pressure on the wheels. Also check your pulleys...
Interesting. Really like the concept. Couple of question though, what would happen if you remove too much surface material or want to face the...
You will likely find over the years the jobs you tackle and the tooling available will require you purchase a few more collets than just the two....
I can't remember if I had any concerns doing it as it was a fix or bin situation. Simply pulled pulleys off, removed grub screws, drilled out and...
The same tb6600 chips that I had issues with afraid to say. I can't be certain that current was the only issue that caused them to loose steps but...
what drivers are you using? I had endless problems similar to yours with a list of drivers
Could have one that slips and the others ok.
Yup tried that initially, worked for a while, did loosen again tho.
The arcs to me look to be right, how possitive your pulleys are not able to twist slightly on your motors? I found you can't get enough torque in...
