Separate names with a comma.
Some features disabled for guests. Register Today.
I figured a custom plate was needed but hoped to find something already made. I've got some 3/8" 6061 on the way.
Did you come up with a good mounting method?
I know the Ox is old news but I hate to let it go to waste. I built my Ox is March of 2015 and it's cut many projects for me with little issue....
My original Ox has become a corner queen to, incidentally this happened after I moved as well!
I don't think your motors are binding, sounds like a step issue. Increase your steps/mm, also double check all of your wiring to the steppers....
[ATTACH] Adam, I experienced the same issue when I built mine. A solution that worked for me was to create a flat spot on the lead screw shaft...
Switching gears for a while isn't that bad. An Arduino Nano with a screw shield is a very cheap solution for short or long term! I have my CBeam...
Stepper driver brackets printed with PLA plastic. Also created and printed a inline fuse holder for voltage to the drivers.
Slowly getting my C Beam XL control box figured out. So far the high voltage side is complete and working flawlessly. I decided to keep the ATX in...
Hey MG, you previously mentioned that I should "definitely fuse each motor driver individually." Is that to say fuse each driver to ground? Or...
I have a shiny new CBeam XL waiting for a brain, makes a good catch all though!
Thanks for your input MG! I'm not opposed to purchasing new steppers or any other parts. Those steppers were supposed to be for another large...
Alright folks, just added a C-Beam XL to my shop. I have an OX with an XPro, which will be replaced the second it dies, and a couple 3d printer....
Hey guys, lighten up! Nobody here pre-ordered or sent money for a new controller! I'm just as excited and just as impatient as everyone else but...
Your killin' me smalls!
