Separate names with a comma.
Some features disabled for guests. Register Today.
Quite a few updates since my last post. I got it all working with off the shelf parts, but was not satisfied with the quality of prints that i was...
This is my first attempt at a 3d printer and with not owning one already I am limited to off the shelf parts and whatever I can fab with a...
Sorry it has been so long since updating. Have been working a ton and had some downtime due to broken parts. Got it working again today. Adam the...
Thanks for everything Keith. I just bought a load of wire so i can ditch most of the 16ga that i used from the home store, it is a little large...
Thanks keith, that was my next question if the config file only used whole numbers, or if decimals worked. That cube was with .3 layer heights....
It is pla, going to do a few more test prints to get it dialed in more. What is an acceptable deviation on PLA, or should it be spot on?
Got it up and running and my first prints. Well, sort of first prints, had a couple failed prints to start with and had to tweak a little bit....
Updated the solidworks file, let me know if that works for you.
I'm new to solid works. What do I need to do, post all of the files for the open builds parts that i used and such?
Of course not. That's what is so great about all of this. I stole from many different builds to compile mine.
Thanks Keith. That makes sense now. I do have 1.8 deg motors so hopefully everything works well. Adam, they are a KFL08 pillow block i got them...
Thanks Keith. After reading the article, i understand the concept behind microsteps and their downsides/upsides. But the rest of the information...
Got all my parts in last week while i was out of town. Got more done than i have pictures of, but am out of town again. Got the Z all set up and...
We will see. I was concerned on the same thing myself. I am looking at them as more stabilization of the gantry in x and y. I hopefully will be...
