Separate names with a comma.
Some features disabled for guests. Register Today.
I see what you were saying the fake the home method is the calibration of the steps. I did that this morning and it seems to be working. I only...
I have not tried fake the home method. I should also state I'm running belts on x and y axis and lead screw on z axis not ball screws I notice...
Custom built machine. I am however using blackbox x32 and the cnc interface and power supply from open builds. The current issue I am having is...
Thank you guys for the help by the way I do very much appreciate it
2.5mh on these it was stated in this thread no higher than 2mh so will that be an issue
So according to that data sheet I should be good to run these motors with the openbuilds set up?
these are the kits I bought spindle Amazon.com Nema 23 (doesnt give me much info as far as voltage and current goes) Amazon.com
I bought the power supply from open builds as well
Thabks for the reply i am going to check this out now and Sorry I meant the cnc interface touch not the touch plate.
Maybe I did not look hard enough but where can I find information on how to hook up and run the x32 and the touch as I have built my own cnc...
So I just made the purchase today of the blackbox x32 motion controller and the interface cnc touch. Where do I start on learning how to use this...
I started this printed build about 7 years ago and then about half way through it got pushed to the side for several years I have recently...
