Separate names with a comma.
Some features disabled for guests. Register Today.
Finished everything up, mounted my control box, ran the water lines and powered everything up. Getting an error on my A Axis that is connected to...
No you can... you will have to open up the top and modify the wiring that goes to the potentiometer and wire it to a PID, or speed controller...
Electrical box... there are smaller ones but that will be determined by your boards, etc......
Welcome to the world of precision machining!!! That 400w spindle is ok for wood and plastics/polymers. The 800w will be a good start for...
Almost there...
Mixed bag of pics... Ill let you figure out what they could be LOL
This would be an excellent upgrade for those wanting a slightly larger spindle with carriage plates that allow beefier 80/20 extrusions for y axis...
Yeah, wasn't bad at all. Kept it under the 3 kilo limitation also!! Have other pics to post up today to... I do think I will go with the 280oz...
Here is an excellent reference.... [IMG]
No, they all don't have the open builds logo but the wiring is the same and from what I've researched, the black wire 4 wire model is the lesser...
Ryan, I have a question. The motors you sent me, they have different markings on them. I'm assuming they are all the same? I've found some site...
More wire work. Shielded twisted pair and some CAT7...
Question, what controllers and drivers are people using? I have a 32 bob with an ESS. Was wondering if anyone knows the accurate pin out for the...
Thanks Ryan!! Got some more work done on the controller box. Hooked up the fans to the buck, mind the wiring... LOL Then did a dry run. Added...
Hey everyone, i've done more work on the control box. Added 5 80mm Apevia Fans. 3 push and 2 pull to keep the fresh air intake up. Received some...
