Separate names with a comma.
Some features disabled for guests. Register Today.
You have a lot going on there. xPRO and Arduino do different things. xPRO takes g-code (generated or programmed) and moves the axis handling all...
Hey team, I am just learning Fusion 360 but I created a drill plan for a waste board for the XL Gantry Plate. Note that the 1:1 PDF generated 120...
Thanks-- I am looking at the PDFs of the models; however, I do not see one for the C-beam XL Plate.
Anyone have a template for the screw holes?
Another NOOB question... how do you connect the sacrificial material to the bed? In the photo above it looks like counter-sunk screws. What size...
Note that I cycled power as you suggested and observed the correct displacement with: 800 pulses/rev, 1101 SWX, & 100 SPU. Thankyou for the tip.
Using the defaults on the Planet-CNC software. Will publish them in a bit. Update: added settings export.
What are the errors? I do an emergency stop to disable the motors, then make the switch changes.
I am still having some issues with my configuration. You can see my configuration here. Essentially, I am not finding any difference with the...
JTBC: they ARE assuming a 200 step/revolution? This really doesn't make sense for me as then there is no 1:1 (ie. you can ONLY µstep).
Can someone explain how the micro stepping works with the DQ542MA drivers? The table on the drivers has 400, 800, 1600, ... Does this table...
I have the board; however, I am a NOOB so just trying to figure it all out. There IS a JOG jumper and I have seen videos with the keyboard for it;...
What were your final switch settings? I too am doing this for the first time.
Has anyone wired up the DQ542MAs with the CNCControllerMk3/4? What colors map to what driver terminals? What switch settings?
