Separate names with a comma.
Some features disabled for guests. Register Today.
Just updated Fusion 360 and the Open Builds post processor no longer functions. Is anybody else experiencing this issue? Thanks, Michael
So, the post processor is working quite nicely. Digging the Black Box upgrade from my Gecko drive and my old 32 bit system running Mach3. Thanks...
Thank you!!! Agreed. I wish they had more documentation on their site. I will give this a shot and let you know the outcome. Much appreciated!...
The post processor from the link seems to work but may need some tweaks. for some reason the Z axis F rate is the same as the X&Y F rate even...
Adding a G20 command edit in the g-code seems to have done the trick. Now to dial in the calibration. I also need to figure out how to strip out...
So I believe the Shapeoko post processor is sending the output scaled to metric. Is there a simple fix to convert to imperial?...
Awesome! Thanks. I’m sure I will have more questions soon.
Thanks! I will give this a try, again. I am getting setup now with using Control and the Black Box as I was previously running Mach3 on a 32 bit...
I am wondering if anyone uses madCAM with their Black Box controller and if there might be a post processor for this. Otherwise, is it difficult...
