Separate names with a comma.
Some features disabled for guests. Register Today.
Hi, I joined the Openbuilds community exactly a year ago and bought myself a 1500x 1000mm OX kit, TinyG and a Kress 800w spindle. Since then I...
I didn't yet no, I will do that next. I just find the programming strange as I would have thought it shouldn't have any limits (the widget) it...
hey guys, bit of an update. I got the TinyG back up and running (still no idea what happened but disconnected all the limits and outputs and...
Hey thanks! Yeah I'll lower the velocity down to 5000 or 6000 max which is what it was on previously! I've been reading as much as I can and...
Legend thanks, I hadn't tried to Z min limit as off which is why it's going into Spdir angry mode. Yeah those Vels were way high.. I was...
I just read up about the stepper motor current pots on the TinyG, these are in the middle and haven't been adjusted... Im running nema 23s and a...
I bought my Ox about 2/3 months ago through Makerstore and I had really good email contact with Steve up until after I had put most of it together...
Hey guys, a few questions I need to sort out (once the Ox is back running, see TinyG went bangG) Firstly the set up, As title says I have a 1500x...
Hey guys, First thread and build.. and it's not on a good note unfortunately. So I bought my OX build and TinyG a few weeks back now and had...
Hey Iwan, thanks again for this STL, it came out great. I am using an OX so I have the 20 x 60 Z axis which puts it off centre so I just drilled...
