Separate names with a comma.
Some features disabled for guests. Register Today.
Looks like a backlash problem most likely slack in your belts
Just thought I'd follow up. Picked up some sikablock m600 which is 600kg/m3 tooling board from easycomposites in the uk. a 500mm x 1500mm x 50mm...
I'm using cheap chinese LJ12A3-4-Z/BY proximity sensors that are available on ebay or aliexpress for $3-4 each. Haven't had any problems with them.
Anyone cutting proper tooling board on their machines? Just wondering how they cut compared to plywood and MDF. Looking at 240kg/m3 and 600kg/m3...
The smaller one is for just the spindle cable. It seems to work just fine. Not sure what there is to be gained by replacing the two with one...
I used spabond which is a pre thickened rubber toughened epoxy that is used commonly in boat building. A good bit of effort went into make sure...
[ATTACH] Thought that I'd take a few minutes and share some pictures and thoughts on building my OX variant. I wanted a machine for mainly...
nate campbell published a new build: Modified OX with carbon fiber reinforced X and Z axes. 1500mm Y, 1000mm X and 120mm Z clearence Read more...
Just be aware that a large amount of the play in these systems is the fastners bending. Longer fasteners = more bending.
You can't go to low on the LEDs, LCDs don't pass UV wavelength. There has been quite a bit of research into this idea over at buildyourownsla.com....
Wow, you don't like the McMaster website? I can't think of a better website for buying technical goods tools. I used to be a purchaser and spent...
I built a 1000mm x 1500mm OX with the inside plates but I'd trade them in a heart beat for brackets to mount the Y rails to the table. My machine...
no, used fairly thin double sided tape. I was thinking about this today. Have people had success with this?
