Separate names with a comma.
Some features disabled for guests. Register Today.
@Geezer70 No worries.. what you planning on doing to your cube ?
ok so the SD card just looks like place to dump all your .cube3 files (the objects you print) there are a couple of other language files and a...
Yeah ill take a look for you :-) Hopfully the sd card is formatted in a way that my windows pc can read it... Ill look at the board when i get a...
Unfortunalty not. The pure amount of wiring makes it quite dificult.. you might be able to get it in the base almost under the printer but not...
There is so much more that could be added to this firmware. but i have a 1 year old so do nt have the chance atm. Thing it does not support Self...
Yeah I strip them down, the cartridge print head actually comes apart and clips back together.. at first I though it was sonic welded o...
i use 1.75 with no issues in fact.. measuring the filament from the original cube was quite inconsistent so yeah 1.75 is all good :)
I've not experienced a problem with it skipping if the table is bumped! But yes there is going to be a lot of redundant LEDs IR sensors, 1 wire...
Yes they are Fans (12v) that kool the extruder stepper motors! and are "always on" (very quite to be honest!) follow up to this.. although they...
The Extruders To get access to the extruder you will need to remove the following screw and lift off the top cover [IMG] This should give you...
@Rick 2.0 The Steppers model are 17PM-k374BN01CN for the 2 extruders and the 3 axis motors are 17PM-K077BP10CN all manufactured by the Minebea co...
So do people want more ?
Okay so good news and bad new good news is that I have figured out ALL of the components required to convert this into a fully working RepRap and...
Hi all I am going to pull apart my cube 3 3D printer with the aim of replacing all electronics with RAMPS 1.4 as im fed up with the over priced...
