Separate names with a comma.
Some features disabled for guests. Register Today.
Nlucier, You could try changing your G-code so that the points are always approached from the same direction. So when moving from row 1 to row 2...
fast-decay will make the motors a little bit noiser, and is less efficient. However the DRV8825 driver used in the XPro can have trouble managing...
you can type values into the WPOS boxes; so once the probe has completed, enter your plate thickness as the current Z Value. Alternatively you...
It's been almost a year since I got my Ooznest OX, so I thought I post an update and go through some of the mods I've made over the year. The...
You can wire two motors to one driver without halving the current, or loosing any torque. If you wire them in series rather than parallel, they...
You can also wire two motors in series to a single driver, this way they get the same current, but effectively each get half the drive voltage....
Adding some 1uf capacitors between the inputs and ground, solved the problem on mine.
I use a similar configuration, controlling my spindle via a solid state relay. M3 & M5 seem to just work for me, no need to set S, no startup...
That's my build; to be honest I think the DRV8825's are only borderline capable of driving NEMA 23s. While they can theoretically drive 2.5a, the...
Well I've only done a few test cuts, but everything seems fine so far. [IMG]
Hi, I got my ooznest up and running yesterday :); [IMG] Still quite a bit to do but getting there. I've started out with a budget control...
