Separate names with a comma.
Some features disabled for guests. Register Today.
Noticing an issue in Mach3. When i issue G0 Y100 or even G1 Y100. The DRO shows 99.994. It is consistent on both x & y axis. I have tried...
***** Update 10/25/2016. ****** NOx up and running. Video of the NOx bringing Elvis to life. [MEDIA] This is my first build. I am naming this...
Twin C-beams bolted together. I have not put a dial to it, but it is rigid. I am sure i have more flex on the Zed, even after rebuilding the Zed...
Pulley slippage :( Had the 20mm GT3 but had to bore it out to 8mm for shaft. Not enough bite left to hold set screws consistently. Changed...
Rebuilt the Zed with 8 wheels on the outside of the C-Beam. Got the router trammed. Pretty happy with the level. Now trying to calibrate the X...
I am experiencing Z-axis tilt. Definite waves with 1 side low when I try to level my spoil board with a 1/2" bit. I am clamping the Bosch Colt...
Still tweaking the motor tuning. Currently have the speed set at 12000mm/min and acceleration at 200mm/s*s. Not real sure what i should be...
River Rock Controller - as Solid and Smooth as stone.
Anyone have any experience with a doubled belt (belt and pinion)? Is the bottom belt glued? Taped? Or just tensioned in the v-slot?
Some updates on the Zed P_20160807_163412 by P. ry posted Aug 7, 2016 at 5:36 PM P_20160807_171823 by P. ry posted Aug 7, 2016 at 5:36 PM
P_20160729_132842 by P. ry posted Jul 29, 2016 at 7:59 PMP_20160729_132805 by P. ry posted Jul 29, 2016 at 7:59 PMP_20160729_132733 by P. ry...
Trying to reinforce the wheels to keep them from flexing. Because I wanted to support the Y, I couldn't use a full plate on the inside.
Started :) http://openbuilds.com/builds/nox-1500mm-x-1500mm-c-beam.3784/
