Separate names with a comma.
Some features disabled for guests. Register Today.
Don’t need them anymore. Pay for shipping and they are yours. After you get them, if you think you got a great deal please drop a few dollars to...
Dropped voltage down to .45 so looking at just under an amp on the motors and they seem to run quite a bit cooler. Still pretty warm after a...
Well, checked the x and two y steppers and they’re the same but doh! .7 volts so I guess that would be 1.4a correct?? These aren’t Openbuilds...
That is what I thought as well. I’ll recheck tonight. Thanks Paul
Hey guys. Haven’t been on in a loooong time. Finally getting around to fooling with my small acro. Running the Nema 17’s with a Gradus M1 board...
That is SO cool... On my list to do.. Thanks!!!
Here goes! 3lb, 7oz. ;)
Thanks David. Will give that a try Paul
Having a "laser on" issue that I hope someone can help with. Arduino Uno with a CNC shield V3 running GRBL 1.1f. Upon startup all is fine but...
David. Thank you very much for that and for the excellent reference link. Though it is for Linux, I assume the commands hold true for all...
Whoops. Never mind. Found the error in my G Code. Copy and paste bit me in the butt. Paul
I'm using NEMA 23's and taking 1mm cuts at a feed rate of 250mm/min. That should be plenty safe shouldn't it??
Hi all. Trying my first kick at a quick bit of G Code to mill a slot in some ply. It's 19mm thick and I'm using a 1/2" bit. All seems to go...
I picked up a 1" cutter at Woodcraft for about 30 bucks and change. It is a Whiteside 1/4" shank. Paul
