Separate names with a comma.
Some features disabled for guests. Register Today.
At the end of the track.
Digger, I tried the "T" nut method for the belts, it did not work very well for me for two reasons. One as you tighten down on the belt it moves...
Good idea! thanks.
How are most of you squaring up your OX? I thought I was square when I built the frame, the bottom of the gantry would hit the front and rear...
I really don't want to know, but a lot less that a pro built machine. When I get done (and it works) I'll add it and post it here.
Deadman, I'm just finishing mine up hopefully a test run this weekend or early next week. Be careful of the BOM on the build page it is for the...
Probotix PBX-RF it's an isolated breakout board.
I am building a Ox with 1617 Bocsh router as the spindle. I'm just finishing up the controller box and I want to be able to turn the router on/off...
Rich, don't get me wrong I buy some things from HF too, but the first time the HF router shells on you in the middle of a job and ruins the part...
I'm sure Chris can make you one, but I wouldn't waist the money for the HF trim router. Mount will cost you more than the router and you'll be...
Also I was planing on leaving one belt off untill I know there moving in the same direction.
Great, so there is a slave menu in the software, guess I need to look at it closer. I agree that giving each motor it's own output pin is better....
Hi guys, my 2x4 Ox is comming together thanks in no small part to Chris Laidlaw for his machine work. I am curently wireing but there is one thing...
