Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Recent Content by Paul_artcam

  1. Paul_artcam
    Post

    Struggling to get X-Carve motors to move with BlackBox x32

    Can't remember but I did a Google search for "xcarve grbl" or similar
    Post by: Paul_artcam, Jan 2, 2023 in forum: Motors
  2. Paul_artcam
    Post

    Struggling to get X-Carve motors to move with BlackBox x32

    Thanks Peter, I found some grbl settings for Xcarve and setup a custom config. X and Y motors accelerate, feed and deaccelerate nicely. Rapid...
    Post by: Paul_artcam, Dec 2, 2022 in forum: Motors
  3. Paul_artcam
    Thread

    Struggling to get X-Carve motors to move with BlackBox x32

    I can't get the X-axis motor to rotate on my XCarve. I've removed all belt pressure, OP Control sees the x32, I have 24V attached, but jogging...
    Thread by: Paul_artcam, Dec 1, 2022, 5 replies, in forum: Motors
  4. Paul_artcam
    Post

    M3 Nut plates

    I'm new to these designs but M3 seems too small for clamping, especially with my middle aged eyes;). M4 would be easier to use, stronger and more...
    Post by: Paul_artcam, Mar 12, 2016 in forum: Share Parts
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice