Separate names with a comma.
Some features disabled for guests. Register Today.
Hi, I’ve built the code for the picobob which doesn’t use shift registers and loaded this onto a bare pico on a development board once I cleared...
I have ordered a PicoCNC board so this should have the correct alarm/run signals connected. I tried another firmware build with comparability set...
Hi, I would like to use the openbuild control software 1.0.370 with my pico, I really like the interface. (At this stage, I am only using a bare...
Thank you so much, that has fixed the problem. Peter
I have recently updated to Control V1.0.273 and the X,Y,Z boxes on the display panel (upper left hand) all show 'disabled'. If you jog and then...
