Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks Jonny, I will take that note into consideration
Nice build, Looking for the plasma torch assembly.
I have been looking at building a CNC router for long time, and had worked on many 3D models, until I came across the V-Slot. I decided to start...
Well it was a long trip, I did not think it will take that long, 4 prototype, working on weekends and waiting for ARAMEX shipments from CNC shops....
Thank you for the note, I have tried to minimize the lateral and axial loads, however I need to wait till the controller arrive to put all to...
Hi, below some pictures which shows the totally new design for the X-Z axis. This picture shows the 1/2 inch Z-Axis plate holding the...
Yesterday, the hardware arrived, almost 6 weeks, but it was worth the waiting..... This is the first time for me to go through the whole cycle of...
Raed Al Nuaimi published a new build: Another modification on the OX Read more about this build...
@Robert Hummel A Job Well Done. I need 2 full Kits, please PM me [email protected]
